The daily maintenance of the closed gantry double-point high-precision punch press is a key link to ensure its long-term stable operation and high-precision processing. The following are several key points of daily maintenance:
Cleaning and maintenance: Regularly clean the punch press and its accessories, including the machine surface, transmission system, hydraulic system, electrical control cabinet, etc., to remove oil, dust and debris. Cleaning work not only helps to maintain the beauty of the machine tool, but more importantly, it can timely detect and deal with potential fault hazards, such as oil leakage, air leakage, etc.
Lubrication inspection: Check and replenish the lubricating oil of each transmission part, sliding part and friction part of the machine tool to ensure the normal operation of the lubrication system. The selection of lubricating oil should meet the requirements of the machine tool, and the oil quality should be checked regularly, and the deteriorated lubricating oil should be replaced in time. Good lubrication can reduce wear and extend the service life of the machine tool.
Electrical system inspection: Regularly check the working status of electrical components such as electrical control circuits, buttons, switches, etc. to ensure that the electrical system is safe and reliable. Failure of the electrical system often causes the machine tool to stop or the processing accuracy to decrease, so it must be highly valued.
Precision inspection: Check the precision of the punch press regularly, including the punch position accuracy, blanking clearance, mold installation accuracy, etc. Precision inspection can timely detect and adjust the precision deviation of the machine tool to ensure the processing quality.
Mold maintenance: The mold is an important part of the punch press, and its state directly affects the processing quality and efficiency. Therefore, the mold must be inspected and maintained regularly, including cleaning the mold surface, checking the mold wear, adjusting the mold gap, etc.
Safety protection inspection: Check whether the safety protection devices of the machine tool are intact, such as protective covers, emergency stop buttons, etc. At the same time, remind the operator to comply with the safety operating procedures to ensure personal safety.
In summary, the daily maintenance of the closed gantry double-point high-precision punch press involves many aspects and needs to be carried out comprehensively and meticulously. Through daily maintenance, potential problems can be discovered and dealt with in a timely manner to ensure the stable operation and high-precision processing of the machine tool.
